BIONIME GM550 Manual de usuario descargar pdf (Pagina 19)

Recalling Test Result and Average

The Meter is able to store 500 test results with time and date automatically. If your

meter has stored 500 results, which is the maximum memory of the meter, the newest test result will

replace the oldest one. To recall your test memory, start the meter without test strip inserted.

Rightest GM550

2. To finish reviewing memory tests, press main button again, and you will enter the Average screen.

By pressing the right button, the display shows "AVG" on the upper right corner of the display and

the average value for the actual day. By sequencely pressing the right or left button you will get to

the 7-days, 14-days, 30-days and 90-days average of your blood glucose values.You will see the

number of the calculated days on the lower left corner and the number of the calculated readings

on the lower right corner.

1. Press the main button to switch from the time mode to the Memory screen. First

you will see the ”MEM” symbol on the up per left corner of the display. When

you press the right button, the latest result will be displayed. By pressing the

right button sequentially former test results will be shown in historical order.You

will see the sequence number on the lower right corner and the year on the

lower left corner of the display followed by date and time of the measurement.

Note: The right button is for reviewing the tests with sequence number increasing, and the left

button is for reviewing tests with sequence number decreasing. The sequence no “1” is the latest

result while sequence no “500” is the oldest test result.

Performing a Quality Control Test

Maintenance

Keep your meter and test strip free of dust, water or any other liquid. Store the meter in the carrying

case if you do not use it. If meter is dropped or damaged, perform a Quality Control Test before

doing a blood glucose test.

Cleaning Meter

Clean the outside of the meter with a damp cloth and mild soap/detergent. Protect the test strip port

from getting wet.

Please always keep the two metal contact points of the test strip port clean. If you find it's covered by

dust or impurities, please clean it with a little soft brush.

The meter might not be activated when you insert a test strip but the contact points are heavily

covered by dust or impurities.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

BIONIME GM550 Manual de usuario Pagina 19